I was a senior, computer science, graduating in July, a software company to do similar work in the network engineers. The boss asked me out CCNA examination within two months, although no reported remedial classes, I think PASS should not be a problem, and that some under the sea. . .
He is often out new topic to me. I have not actually done these. . . There is a 3550 hand, but I will not play. This is not, he was given a Road that, I have no idea. . . There are some books to see VLAN. . .
Will XDJM where a Thank you.
Is as follows :
A map
A router:211.188.195.1
Gi zero in a switch:211.188.195.2
Gen middle line, or UTP cable is ordinary?
Then vlan70 (211.188.195.0/30) vlan70 name is? 211.188.195.30 is gateway?
Then understand what this chart? VLAN division is not necessarily the VLAN 2 from the beginning?
IP address is Harry? It is not the company's IP?.
If the actual operation, the need to prepare for the switch and a router?
Thanks to the code point of order here. Oh 呵~~
Hello, pretty please about the b na.
Why is a girl who posted reports? This made me feel inequality between men and women.
!
Interface Gi3/0
211.188.195.1 ip addr 255.255.255.252
No shu
!
Cisco Catalyst 3550
!
Interface Gi0/1
Switchport access vlan 70
Switchport mode access
No ip address
!
Interface vlan 70
211.188.195.2 ip addr 255.255.255.252
No shu
!
!
211.188.195.1 ip route 0.0.0.0 0.0.0.0
!
Based on personal understanding (no plan), your routers and cisco catalyst 3550 through fiber connector;
70 vlan is vlan you an ID for you. Divided vlan vlan two from the ID from the beginning entirely in accordance with your personal habits.
IP addresses specified that if the experiment is done, you may designate. If, for the corresponding IP address on the need to do the planning. Address or even private legal address.
As you are MM, I am a shortcoming.
Read your CMD, good excitement, which is a bit of SENSE, the weak weaker asked. . .
1)! What? Also
2) is not in the switch (config-if) under dialing #?
3) no shu what? Followed protocol on the Line Interface GigabitEthernet0/1, changed state down to what is meant to you?
4) Why is Gi3/0 that router?
5) Why did not use such CMD vlan database?
6) After what can be configured test configuration is effective?
Sorry. . . Too many questions. . . //bow
QQ:17355779
TCP also re-learn again
I asked the boss, he said SPEED ROUTER is virtual, so long as the allocation SWITCH and the FORTRAN computational GOTO etc.].
Read your CMD, good excitement, which is a bit of SENSE, the weak weaker asked. . .
1)! What? Also
2) is not in the switch (config-if) under dialing #?
3) no shu what? Followed protocol on the Line Interface GigabitEthernet0/1, changed state down to what is meant to you?
4) Why is Gi3/0 that router?
5) Why did not use such CMD vlan database?
6) After what can be configured test configuration is effective?
Sorry. . . Too many questions. . . //bow
QQ:17355779
3) no shu what? Followed protocol on the Line Interface GigabitEthernet0/1, changed state down to what is meant to you? Meant to activate the port, Port DOWN swap is no wiring.
Too many questions, I suggest reading the information and then asked questions (NA study the best course). Even if you have no means to be female
TCP too esoteric, recommend basic things.
Everyone here are hoping to get help or help others. But our time is very valuable, people will be able to ask questions following principles, efficient. 79!
1. In your question, please use the Google search solution, or whether the search was discussed at the forum similar problems plots in question is a waste of everyone's time and energy;
2. I should be grateful if you would have a platform and version of your problem clearly. For example, the DSO Linux+ Apache 2.x + PHP installation, particularly when you are asking about Linux on the problem, we would like to point out;
3. All information will be posted out wrong. This is very important, we have nothing to lose face, who were taken to a step-by-step;
4. Will be asked to describe the problem clearly, not only you will understand that other people have understood that others can not help you. "My Apache mountains, how do? "This is your own problem Morenhuida;
5. Special attention is that you should put a question to be solved first, then your solution, and that specific details to the middle of a problem. Do not jump on the details of a line, the final solution is not found on, going around in a big circle;
6. The most important thing is, when you ask it is finished, please remember to come home and see the answer. If more than one day, on top of that your message was to prevent others drowned;
7. When you have identified the correct answer, please Huitie, and expressed thanks to respect other people's labor. Newcomers often ask, it was gone, too Huitie or three days or a week before to ask the same question again, please do not be professional enough to avoid acts;
8. If you found the solution to the problem on their own, you will have your answer posted back to share with you not only add "resolved." Even the wood because it is your own problem. But if you can say that nobody else might not have committed the same mistakes;
9. At any time, have any further questions, please contact timely and illustrated, it is for your services. And free. PM, not to say : "Please help me look at the Forum, a network message." I should be grateful if you meant the government payments are capped, more accurate positioning;
10. Question, the definition of you heading to the scale of the problem can not just write down "expert help" and "events" in this title. Ask questions, as specific as possible, do not ask, for instance, "how to learn Windows 2000?." This issue is too great, the best answer is to buy the book, first sweep literacy. "How to configure Cisco routers on the routing strategy? "This specific issue is popular;
Better questions are as follows :
CODE
Theme : Apache 2.0.43 + PHP 4.2.3 (DSO Mode) posting of documents to the wrong problem
:
Redhat 8.0
PHP 4.2.3
Apache 2.0.43
DSO mode installation
Phenomenon : upload documents to the wrong mistakes. Upload length of the document and not the original documents.
X 2.0.43
. /configure --prefix=/usr/local/apache --enable-so --enable-cgi --enable-deflate --enable-ssl
Make
Make install
PHP install
. /configure \
--with-apxs2=/usr/local/apache/bin/apxs \
--with-mysql=/usr/local/mysql \
--prefix=/usr/local/apache/php \
--with-config-file-path=/usr/local/apache/php \
--enable-track-vars
Make
Make install
Httpd.conf :
LimitRequestBody 20971520
Php.ini :
Memory_limit = 20M;
File_uploads = On;
Upload_max_filesize = 20M;
Post_max_size = 20M;
Test code :
Upload.php
"?php Print_r ($HTTP_POST_FILES) ;echo $php_errormsg; ?<FORM ENCTYPE= "multipart/form-data" ACTION= "upload.php" METHOD=POST<INPUT TYPE= "hidden" name="_ftn1" "MAX_FILE_SIZE" value= "1024000" "" INPUT NAME= "UploadedFile" TYPE= "file", "<INPUT TYPE=" hidden "name="_ftn1"" set "value=" go "TYPE=" "INPUT" submit "VALUE=" Upload "and" </FORM> "/ BODY></HTML>
Results :
Array ([UploadedFile]> Array ([name] image/gif [tmp_name]>>> avatar.gif [type] /tmp/phpvdbGoP [error] [size]> 120792> 0))
There is the size and the original document is different!
You can understand that more people can see you. In this way, you can get more answers and suggestions. The problem is I find that some people do not know where the stickers in the end, has been posted in the first Halo, so the others will give you all to no avail, even in a few days plots posted the same problem.
There is one point that those who wish to understand and question firmly in mind : To some extent, all those questions are reaping without sowing, therefore, when the answer to the problem End, can see the answer, and say thank you is the most basic human rules. Similarly, the answer will again look at the issue of whether those issues were resolved, there is no better solution. No questions were not always complaining about the players and no one to answer your question, look at the issues expounded their platform, and other related information is wrong and wrote understand. Meanwhile, answering questions of the people you respect.
We need to build up a good forum, but more important is to maintain an order! Agree?