How the Internet? I bought a Taiwan IBM8131 machines installed win2k and redhat9 system can be connected under win2k. Antimoine, has successfully installed a network adapter driver, but no Internet access. No matter how the network set up changes too. Starting indicate the type of information is unknown NVRAM, Determining IP information for eth0. . . Failed; no link present. Check cable? Eth0.inf document reads as follows : Description Broadcom BCM5751F TX PCI Express Driver_Name bcm5700 Driver_Version 8.2.18 Bootcode_Version PCI_Vendor 0x14e4 PCI_Device_ID 0x167e PCI_Subsystem_Vendor 0x1014 PCI_Subsystem_ID 0x02f7 PCI_Revision_ID 0x11 PCI_Slot 0 PCI_Bus 2 PCI_Bus_Speed PCI Express Memory 0x20000000 IRQ 5 System_Device_Name eth0 Current_HWaddr 00:11:25:ef:2a:17 Permanent_HWaddr 00:11:25:ef:2a:17 Part_Number Link unknown Auto_Negotiate on Speed_Advertisement 10half 10full 100half 100full Flow_Control_Advertisement pause Speed 0.00 Duplex 0.00 Flow_Control 0.00 State down MTU_Size 1500 Rx_Packets 0 Tx_Packets 0 Rx_Bytes 0 Tx_Bytes 0 Rx_Errors 0 Tx_Errors 0 Tx_Carrier_Errors 0 Tx_Abort_Excess_Coll 0 Tx_Abort_Late_Coll 0 Tx_Deferred_Ok 0 Tx_Single_Coll_Ok 0 Tx_Multi_Coll_Ok 0 Tx_Total_Coll_Ok 0 Tx_XON_Pause_Frames 0 Tx_XOFF_Pause_Frames 0 Rx_CRC_Errors 0 Rx_Short_Fragment_Errors 0 Rx_Short_Length_Errors 0 Rx_Long_Length_Errors 0 Rx_Align_Errors 0 Rx_Overrun_Errors 0 Rx_XON_Pause_Frames 0 Rx_XOFF_Pause_Frames 0 Tx_MAC_Errors 0 Rx_MAC_Errors 0 Tx_Checksum on Rx_Checksum on Scatter_Gather on VLAN off NIC_Tx_BDs off Tx_Desc_Count 120 Rx_Desc_Count 200 Rx_Jumbo_Desc_Count 0 Adaptive_Coalescing off Rx_Coalescing_Ticks 18 Rx_Coalesced_Frames 6 Tx_Coalescing_Ticks 200 Tx_Coalesced_Frames 35 Stats_Coalescing_Ticks 1000000 Wake_On_LAN off Knowing how to do? Thank you can return! ! ! [ Closed window ]