Rhas3.0 how to support acl? I would like to ext3 file format support / acl Directory, the server only and / /boot and acquiesce in these two cases do not support acl, I would like to re-mount, but I always tell the disk busy, you greatly help out bars, a very tight time I was really no time to check the previous postings. Thank you. Rhas3.0 how to support acl? Boss, I would like to ask is, I do not support the Linux ext3 file format acl, I would like to change how it can support ah. A brother tears. Rhas3.0 how to support acl? Kernel support needs, there are tools to install acl. Rhas3.0 how to support acl? I support the kernal, I just want to support acl into acquiescence at the time, I was defaults. Rhas3.0 how to support acl? As3 should be supported by the kernel ACL used in the document or list, the district where they must use ACL support loading. If it is the local ext3 file system, which can be used to carrying the following orders : Mount-t ext3 -o acl "device-name>;" partition>; For example : Mount-t ext3 -o acl /dev/hdb3 /work If /etc/fstab district was listed in the document, the district will be able to include the item acl choice, such as : LABEL=/work /work ext3 acl 1 2 Then you can use tools to document and catalog setfacl installed ACL Rhas3.0 how to support acl? Thank you reply to my question and I only /boot / 2 partation, I wish I was in the /partation /dev/sda2 acl support, but I want to umount, re-mount. I am unable to re-umount /dev/sda2 in rhas3 reported busy. [ Closed window ]