Linux articulated wrong Disk Array Has been used properly, not articulated after starting from the district on the disk array. Members help the Manga. SCSI subsystem driver Revision : 1.00 Scsi_register allocating 3,820 bytes for FC HBA Ioremap 'd Membase : f8834000 HBA Tachyon RevId 2.0 Allocating 119,808 for 4576 Exchanges @ f6840000 Allocating 112,904 for LinkQ @ f6820000 (576 elements) Allocating 104,456 for TachSEST for 512 Exchanges CpqfcTS : writing IMQ BASE 36860000h PI 36864000h CpqfcTS : SEST f6800000 (virt) : Wrote base 36800000h @ f8834140 FC : New cpqfcTS WWN : 000001h 500508B1000B55F0 SCSI port Chan/Trgt 0/0 Scsi0 : Compaq FibreChannel HBA Tachyon Chip/Board Ver?? : WWN 500508B200505FB4 6 device on PCI bus 0xa0fc IObaseL 0x7000 irq 22, MEMBASE 0xf7ef0000 PCI bus width of 64 bits, 66 MHz bus speed FCP-SCSI Driver v2.1.1 Reference : Short detected. Oh robust Monitor Vendor : Compaq Model : Rev. LOGICAL VOLUME 2.60 : Type : ANSI SCSI revision : 02 Direct-Access Vendor : Compaq Model : Rev. LOGICAL VOLUME 2.60 : Type : ANSI SCSI revision : 02 Direct-Access Vendor : Compaq Model : Rev. LOGICAL VOLUME 2.60 : Type : ANSI SCSI revision : 02 Direct-Access Attached scsi disk sda at scsi0, channel 0, id 0 0 lun Attached scsi disk sdb at scsi0, channel 0, id 0, 1 lun Attached scsi disk sdc at scsi0, channel 0, id 0, 2 lun SCSI device sda : 1052819775 512-byte hdwr sectors (539044 MB) Partition check : Sda : unknown partition table SCSI device sdb : 1052819775 512-byte hdwr sectors (539044 MB) Sdb : unknown partition table SCSI device sdc : 761834430 512-byte hdwr sectors (390059 MB) Sdc unknown partition table : Compaq CISS Driver (v 2.4.27) Cciss : Device 0xb178 has been found at bus func 1 1 0 dev Cciss : using DAC cycles Blocks= block_size= 512 71122560 Heads= 255, sectors= 32, 8716 cylinders= Please take care of. . Em14 : : Linux articulated wrong Disk Array Sdc district table is not correct. [ Closed window ]