Freebsd how plus a piece of card? I was directly added to the new card has been able to identify later, I used sysinstall was installed after the ip address of ping nowhere, I suggested that the host is down ping:sendto : Freebsd how plus a piece of card? Look at the use ifconfig Ifconfig interface up Freebsd how plus a piece of card? Rl1 : flags=8843<UP, BROADCAST, RUNNING, SIMPLE, MULTICAST>; mtu 1500 Inet6 fe80 : : 5278:4cff:fe64:ec29%rl1 prefixlen 64 scopeid 0x2 Ether 50:78:4c:64:ec:29 Media : Ethernet autoselect (100baseTX "full-duplex>;) Status : active I used /stand/sysinstall set up ip address ah, ah how will be no use, no setting? Freebsd how plus a piece of card? There were so ridiculously dmes operation : Arp : *.*.40.62 is on rl0 but got reply from 00:04:dd:28:08:82 rl1 remarks make it clear on what issues? Freebsd how plus a piece of card? I lie in a sub-network card is not aware of any problems with this? I do not want to alias, it is necessary to bind the two network card ip two, but how can not ah? Freebsd how plus a piece of card? Search previous articles, we can ping通, but also words : Arp : *.*.40.62 is on rl0 but got reply from 00:04:dd:28:08:82 on rl1 This is how it all about? Also, I can ssh original link, how the card increases after not succeed? Freebsd how plus a piece of card? [quote][i] Note from the original "wuming122" [/i] released : Search previous articles, we can ping通, but also words : Arp : *.*.40.62 is on rl0 but got reply from 00:04:dd:28:08:82 on rl1 This is how it all about? Also, I can ssh original link, how the card increases after not succeed? [/quote] Then in two cards with a T4 HUB! Em12 em12 : : : : : : : em12 : em12 Freebsd how plus a piece of card? [quote][i] Note from the original "proftpd" [/i] released : Then in two cards with a T4 HUB! Em12 em12 : : : : : : : em12:[/quote] em12 ! So. . Oh! ! I NAT experiment, switch on this. . But not use! ! IP also normal. . This does not suggest that Linux? [ Closed window ]