Creating a port in China nowhere, terminal equipment intact. Show with a show
FastEthernet4/36 is up, line protocol is up
Hardware is Fast Ethernet Port, the address is 000a.8a0f.556f (bia 000a.8a0f.556f)
MTU 1500 bytes, BW 000-Kbit, DLY 100 usec.
Reliability 255/255, txload 1/255, rxload 1/255
Encapsulation ARPA, loopback not set
Keepalive set (10 sec)
Auto-duplex, Auto-speed
ARP type : ARPA, ARP Timeout 04:00:00
Last input never, never output, the output hang never
Last clearing of "show interface" counters never
Input queue : 0/2000/0/0 (size/max/drops/flushes); Total output drops : 0
Queuing strategy : fifo
Output queue : tissues (size/max)
5 minute input rate bits/sec 0 0 packets/sec
5 minute output rate bits/sec 0 0 packets/sec
0 packets input, 0 bytes, 0 no buffer
Beijing 0 broadcasts, 0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
0 input packets with dribble condition detected
333,353 packets output, 76853686 bytes, 0 underruns
0 output errors, 0 collisions, 0 interface resets
0 babbles, late AVLIS 0 0 deferred
0 lost carrier, 0 no carrier
0 output buffer failures, 0 output buffers swapped out
Please master guiding January 2?
1. I FastEthernet4/36 PC connected directly to port, the Port of ping addresses of the respective VLAN. PC Card found that the instructions contract data, and did not receive packet data. However, in normal PC Card instructions also appear in the bottom right hand corner scintillation screen. Data Flow seems to have virtually no admission packet data.
2. I Cisco4006 FastEthernet4/36 made shutdown and no shutdown, half-duplex and full-duplex respectively 10M/100M the relevant provision. Still have not received data packet data only contracts. In Port (FastEthernet4/36) 10M/100M designated time on the PC Link PC Card instructions that no links (that is a cross). In Port (FastEthernet4/36) to the speed auto, directed shows on the PC and PC Card connecting links and normal scintillation also appeared on the screen waiting for the train. Still have not received data packets.
3. Lines and PC normal, there is no problem.
4.ping Port Switch other normal, that is to say with FastEthernet4/36 port VLAN Lane with the other port is a normal, links the address of ping vlan
The same configuration, you have lines for a port. See if we can here only port in the state, the distribution of the fracture not issued, the less the judge some things. Hope that the allocation issued to port. 4.ping Port Switch other normal, that is to say with FastEthernet4/36 port VLAN Lane with the other port is a normal, links the address of ping vlan Can explain this sentence?
Do you mean with the other pc f4/36 inside with a can of ping vlan vlan address?
This is not your mouth connecting the pc f4/36 the issues, such as the setting up of layers?
[ Closed window ]