P4 and UNIX 5.0.5 Members heroes, I used P4 installed UNIX 5.0.5 also how to act, it is not p4 UNIX 5.0.5 can not be installed that way? Also, the UNIX 5.0.5 hardware requirements? P4 and UNIX 5.0.5 Can be installed, but not very good support P4 5.0.5 P4 and UNIX 5.0.5 I have encountered this problem, but not the p4, p2 my HP machine, impossible to install, I used p3 machines installed, and then the hard disk can be put on p2 machines. P4 and UNIX 5.0.5 I installed, in the event of boot : I am by the transport, and then arise. . . . . . Then to be renewable screen of system information, but on my blank screen, not by arbitrary Key effective only important date. How I should do to you? I machine configuration : P4 2.0 CPU Main Board 845PE Memory 256M Disk ST80G Caliper Ti4200 Members urged the heroes! ! ! P4 and UNIX 5.0.5 Not likely to show support for the card. P4 and UNIX 5.0.5 With the LCD is not? P4 and UNIX 5.0.5 This little. P4 and UNIX 5.0.5 Caliper is determined? I try to change the chip. Thank you, old instantly! P4 and UNIX 5.0.5 Xiancun bois put in the end points can be emphasized, you try. P4 and UNIX 5.0.5 SCO P4 505 CPU support, I installed too. P4 and UNIX 5.0.5 Fail to recognize P4 P4 and UNIX 5.0.5 I drive It appeared that I was the only one for one! P4 and UNIX 5.0.5 Thank you for help, I found the reason why. Caliper is (Ti4200) are not compatible. I replaced S364V+ now as well. Very grateful ~! P4 and UNIX 5.0.5 SCO does exist in the display card compatibility. P4 and UNIX 5.0.5 I just p4 machines installed, which is Lenovo Goose series. Also p4 2.0g. No problem. But several attention, you need to pay attention to. 1 p4 running the cpu speed, it will start the examination of the system hardware is there, it will be some anomalies in the system startup process. Main Board in cmos jumper put cpu frequency or lower. This lower rate, allowing the system to have more time to evaluate the hardware. 2 This is a bit of experience, you can learn from here : At the time, there : boot, not the transport, have been waiting for sufficient time, the system under the tacit boot configuration, with such a high success rate activated. This is my experience, you want to help. P4 and UNIX 5.0.5 IBM installed it is not the oh P4 loom [ Closed window ]