I now have a 2950 switches, photoelectric + Fiber Transceiver with a 4000 switches connected with the other, beginning with the links, but after a few minutes not being given, being given the information as follows : ERROR : INTR 2950#SCHAN unit=0 SRC=6 DST=5
OPCODE=20 ERRCODE=5
When being given information only after ip ping通 their management, with 4,000 switches nowhere.
Is this what the reasons are, in Cisco also be found on the website of trouble to look at what it is, the switch is not the issue?
Emergency, the user scene! ! !
Hardware problems For Fiber Transceiver can get. Here I am just here to clients this is a 2950 issue, I think the switch hardware, has asked the manufacturers to replace channel, but either would take three, four days Today, for a switch, or not, check the switchboard cpu占用 only 1%, a low purchase bars or dead, the Cisco product is not designed doubt there will be problems It could also be hardware compatibility problems 2950 is not a good response as a lot of people I have here is that the new 2950 over the many unable to use. Is this situation, Cisco does not know, should not die, so a large company such a bad product [ Closed window ]